Product Name:SpeedyBee F405 V3 30x30 Flight Controller MCU:STM32F405 IMU(Gyro):BMI270 USB Port Type:Type-C Barometer:Built-in OSD Chip:AT7456E chip BLE Bluetooth:Supported. Used for Flight Controller configuration DJI Air Unit Connection Way:Two ways supported: 6-pin connector or direct soldering. Blackbox MicroSD Card Slot:Supported. Please use ≤4GB SDSC/SDHC microSD card and should be formatted to FAT16/FAT32 format. Don't use SDXC cards. Note: Betaflight can only recognize 4GB max. BetaFlight Camera Control Pad:Yes(CC pad on the front side) Current Sensor Input:Supported. For SpeedyBee BLS 50A ESC, please set scale equal 386 and Offset equal 0. Power Input:3S-6S Lipo(Through G, BAT pins/pads from the 8-pin connector or 8-pads on the bottom side) 5V Output:9 groups of 5V output, four +5V pads and 1 BZ+ pad( used for Buzzer) on front side,and 4x LED 5V pads. The total current load is 2A. 9V Output:2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 2A. 3.3V Output:Supported. Designed for 3.3V-input receivers. Up to 500mA current load. 4.5V Output:Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load. ESC Signal:M1- M4 on bottom side and M5-M8 on front side. UART:5 sets(UART1, UART2, UART3, UART4(For ESC Telemetry), UART6) ESC Telemetry UART:R4(UART4) I2C:Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc. Traditional Betaflight LED Pad:Supported. 5V, G and LED pads on bottom of the front side. Used for WS2812 LED controlled by Betaflight firmware. Buzzer:BZ+ and BZ- pad used for 5V Buzzer RSSI Input: Supported. Named as RS on the front side. SmartPort: Not supported Supported Flight Controller Firmware: BetaFlight(Default), EMUFlight, INAV Firmware Target Name: SPEEDYBEEF405V3 Mounting: 30.5 x 30.5mm( 4mm hole diameter) Dimension: 41.6(L) x 39.4(W) x 7.8(H)mm Weight: 9.6g
Product Name: SpeedyBee BLS 50A 30x30 4-in-1 ESC Firmware: BLHeli_S JH50 Wireless Configuration: Full Configuration Supported in the SpeedyBee app Continuous Current: 50A x 4 Burst Current: 55A(5S) TVS Protective diode:Yes External Capacitor: 1000uF Low ESR Capacitor(In the package) ESC Protocol: DSHOT300/600 Power InputL 3-6S LiPo Power Output: VBAT Current Sensor: Support (Scale=386 Offset=0) Mounting: 30.5 x 30.5mm( 4mm hole diameter) Dimension: 45.6(L) x 44(W) x 6.1mm(H) Weight: 13.8g